| ★ wanayoo — archive 1999 http://cisco.com/univercd/cc/td/doc/pcat/140.htm | Nouvelle recherche | Portail wanayoo |
|
|
The single and dual port serial WAN interface cards provide serial connections to remote sites or legacy serial network devices such as SDLC concentrators, alarm systems, POS devices, etc.
|
Product Number |
Cisco 1600 |
Cisco 1720 |
Cisco 2600 |
Cisco 3620/40 |
Cisco 3660 |
|---|---|---|---|---|---|
|
WIC-1T |
Yes |
12.0X |
11.3(2)XA |
11.1(7)AA |
12.0(5)T |
|
WIC-2T |
No |
12.0X |
11.3(2)XA |
No |
No |
|
WIC-2A/S |
No |
12.0X |
11.3(2)XA |
No |
No |
The WIC-1T features the Cisco 5 in 1 connector which supports several serial protocols (V.35, X.21, RS-232, RS-449, RS-530) when used with the appropriate transition cable. This facilitates easy configuration and re-configuration as network requirements change without the need to purchase a different serial interface card.
Note: When used in a Cisco 1720 and 1600 series router, the WIC-1T may also be operated in asynchronous mode. The WIC-1T is not supported in asynchronous mode when used in the Cisco 2600 and 3600 series.
Cables: Cisco 5-in-1 (60 pin) cable support includes
CAB-V35 MT/FC
CAB-232 MT/FC
CAB-449 MT/FC
CAB-X21 MT/FC
CAB-530 MT
Dual Port Serial WAN Interface Cards, WIC-2T and WIC-2A/S
Figure 5-170: WIC-2T
Figure 5-171: WIC-2A/S
The dual serial port WIC-2T and WIC-2A/S provide higher levels of serial port density for a single WAN interface card and are supported on the Cisco 2600 and 1720 series. The WIC-2T supports speeds of up to a maximum port speed of 2.048Mbps. The low serial speed WIC-2A/S supports up to 128Kbps synchronous or 115.2 Kbps asynchronous serial links. Each port can be configured independant of the other allowing support for different physical interfaces (protocol and DTE/DCE). Both cards support mixed asynchronous and synchronous operation on a single card as well.
These dual-serial port WAN interface cards feature Cisco"s new, compact, Smart Serial connectors to support a wide variety of electrical interfaces when used with the appropriate transition cable. This includes: V.35, RS-232, RS-449, RS-530, RS-530A in male and female versions for both DCE and DTE devices. This feature provides easy configuration and re-configuration as network requirements change without the need of purchasing a different serial interface card.
Two cables are required to support the two ports on the WIC.
The WIC-2T and WIC-A/S are supported only on the Cisco 2600 and 1720 series
CAB-SS-V35 MT/FC
CAB-SS-232 MT/FC
CAB-SS-449 MT/FC
CAB-SS-X21 MT/FC
CAB-SS-530 MT
CAB-SS-530A MT