|
Installation
|
Step 1
Gently place the processor with heatsink attached into the retention mechanism slot, so that the substrate aligns with connector.
|
|
Step 2
While keeping the processor edge fingers parallel to the connector, slide the processor package into the retention mechanism until it makes contact with the connector.
|
|
Step 3
Align the substrate key feature with the connector key feature.
|
|
Caution
Make sure to keep the processor parallel to the motherboard during installation. Misalignment of the substrate key and connector key will occur if this is not done.
|
|
Step 4
- Once the slot/key alignment is achieved, press firmly until the processor with heatsink is fully seated.
- Customers may want to wear gloves to protect their hands from SEPP sharp edges..
|
|
| Completed Installation
|
|
|
Note: You will see the T-bar lock into the slots on the ends of the heatsink when the SEPP/heatsink assembly is fully engaged.
|
|
)
)
)
)
)
)
)
)
)
)
